B2 Audio RAGE 3200
B2 Audio RAGE 3200
Couldn't load pickup availability
INTRODUCING THE NEW RAGE SERIES AMPLIFIERS
Relieving the MAs of their duty, the latest RAGE mono and mulitchannel amplifiers wont come up short. Newly added features, decreased footprint & greater power are all on the checklist. With a sleek new forward facing design, these amplifiers are sure to perform just as good as they look!
BIGGER IS NOT ALWAYS BETTER!
Compared to the Riot 1200 and 3200, we have decreased the footprint by 15%. We have also increased the power output by 20% due to entirely new optimized circuits which is directly beneficial to your install and your pockets. All of the Rage series feature our ACCU8 crossovers with designated frequencie clicks on the potentiometers.
(see the manual for a full frequency list).
HIGH VOLTAGE
With todays more advanced battery tech and lithium finding its way into car audio, we have tweaked the operation voltage all the way up to 17.5 V. By doing so you dont need to worry about running your batteries at a low SOC and amplifiers going into protect.
| SPECIFICATIONS | RAGE 3200.1 |
| Frequency Response: | 10 Hz ~ 24 KHz |
| Signal to Noise Ratio: | >90 dB |
| Input Sensitivity: | 6 V ~ 0.2 V |
| Low Pass Crossover 24 db/ Oct: | 50 Hz ~ 20 KHz |
| High Pass Crossover 24 dB / Oct: | 10 Hz ~ 2 KHz |
| Damping Factor: | >200 |
| Power Terminal gauge: |
2 GA |
| Fuse Rating: | 250 A |
| Operational voltage: | 10 V DC~ 17 VDC |
| Dimensions: | 10.6" x 6.69" x 2.26" 270 x 170 x 57 MM |
| Power @ 4 14.4 V: | 1 x 1000 Watts |
| Power @ 2 14.4 V: | 1 x 2000 Watts |
| Power @ 1 14.4 V: |
1 x 3000 Watts |
*FULL OUTPUT POWER ACCORDING TO THE SPEC IS BASED ON A SUFFICIENT ELECTRICAL SUPPLY SYSTEM. IF YOUR SYSTEM IS INADEQUATE, THE EFFICIENCY OF THE AMPLIFIER DECREASES HURTING THE PERFORMANCE!
THE RAGE 3200 WILL NEED A DEDICATED AGM BATTERY OF MIN 150 AH AND 2000 CCA. IF YOU ARE USING A COMMON LITHIUM SOURCE OF 6C, A 50 AH LITHIUM BATTERY WILL SUFFICE.
DESCRIPTIONS OF SPECIFICATIONS
OPERATION BELOW MINIMUM IMPEDANCE WILL STRESS THE AMPLIFIER AND VOID THE WARRANTY. EXCESSIVE HEAT WILL OCCUR, CAUSING THE AMPLIFIER TO GO INTO THERMAL PROTECTION. THE CIRCUIT MAY SUSTAIN PERMANENT DAMAGE AND PROTECTION/CLIP LIGHTS WON'T TURN OFF OR FLASH SEOUENTIALL Y. THE RAGE 3200 CAN NOT BE STRAPPED/BRIDGED.
Read more
Share
