DC Audio 2.0k - 2,000w Monoblock Amplifier

The 2.0kw competition series amplifier is a 2,000 watt mono block. It is a linkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped. It comes with a bass knob and a clipping indicator.

For power inputs it will accept 0 awg for power and 0 awg for ground.

 

Key Features
1 ohm stable
Variable low pass filter
Variable subsonic filter
Variable bass boost
Wired remote control
Clipping indicator

We recommend for installation
1 upgraded battery under the hood
1 extra battery in the rear
Minimum of one 0 awg ran from the front battery to the rear battery
Upgraded aftermarket alternator
Dash mounted voltage meter

	Features	Voltage	2.0kw
Output Power (RMS)	4 ohm	14.4V	600W x 1
2 ohm	1,200W x 1
1 ohm	2,000W x 1
1 ohm	16V	No
1 ohm	18V	No
Input Sensitivity			6V~0.2V
Low Pass Filter	Switchable
( @ 24 dB Slope)	Variable	Hz	35~250
Subsonic Filter	Switchable
( @ 24dB slope )	Variable	Hz	10~50
Bass Boost	Variable	dB	0-9dB
Frequency Response		Hz	15-270
Signal to Noise Ratio		dB	100
Damping factor			150<
Efficiency @ 4ohm		%	Over 90%
THD @ 4ohms			Less than 0.1%
Fuse Rating			200 Amps
Linked Fuse Rating			400 Amps
Indicator	Power		Yes
Protection		Yes
Clip		Yes
Speaker & Power terminal	Mold Type		Yes
Power	Gauge	0Ga
Heatsink Length	inch/mm		17.72" / 450mm
Heatsink Width	inch/mm		9.38"/238mm
Heatsink Height	inch/mm		2.35"/59.6mm

Read more

2,000w Monoblock Amplifier2,000w Monoblock Amplifier