DC Audio 5.0k - 5,000w Monoblock Amplifier
DC Audio 5.0k - 5,000w Monoblock Amplifier
The 5.0kw competition series amplifier is a5,000 watt mono block. It is capable of running up to 18 volts
for up to 7,300 watts. It is alinkable amp and designed to run a 1 ohm per amp or 2 ohms when strapped.
It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 awg for power
and dual 0 awg for ground.
Key Features
1 ohm stable
Variable low pass filter
Variable subsonic filter
Variable bass boost
Wired remote control
Clipping indicator
Dual 0 awg power and ground inputs (both must be used)
We recommend for installation
1 upgraded battery under the hood
1 extra 800ci battery in the rear
Minimum of two 0 awg ran from the front battery to the rear battery
Both 0 awg power and ground inputson amp must have 0 awg ran to them for a total of 4 runs into the amp
Upgraded aftermarket alternator
Dash mounted voltage meter
Features | Voltage | 5.0kw | |
Output Power (RMS) | 4 ohm | 14.4V | 900W x 1 |
2 ohm | 2,300W x 1 | ||
1 ohm | 5,000W x 1 | ||
1 ohm | 16V | 6,000W x 1 | |
1 ohm | 18V | 7,300W x 1 | |
Input Sensitivity | 6V~0.2V | ||
Low Pass Filter | Switchable | ||
( @ 24 dB Slope) | Variable | Hz | 35~250 |
Subsonic Filter | Switchable | ||
( @ 24dB slope ) | Variable | Hz | 10~50 |
Bass Boost | Variable | dB | 0-9dB |
Frequency Response | Hz | 15-270 | |
Signal to Noise Ratio | dB | 100 | |
Damping factor | 150< | ||
Efficiency @ 4ohm | % | Over 90% | |
THD @ 4ohms | Less than 0.1% | ||
Fuse Rating | 500 Amps | ||
Linked Fuse Rating | 1000 Amps | ||
Indicator | Power | Yes | |
Protection | Yes | ||
Clip | Yes | ||
Speaker & Power terminal | Mold Type | Yes | |
Power | Gauge | 0Ga | |
Heatsink Length | inch/mm | 25.59"/650mm | |
Heatsink Width | inch/mm | 9.38"/66mm | |
Heatsink Height | inch/mm | 2.35"/59.6mm |
Read more
~ | |||
~ | |||
5,000w Monoblock Amplifier5,000w Monoblock Amplifier