DC Audio 7.5k - 7,500w Monoblock Amplifier
DC Audio 7.5k - 7,500w Monoblock Amplifier
The 7.5kw competition series amplifier is a 7,500 watt mono block. It is capable of running up to 18 voltsfor up to 9,200 watts.
It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped.
It comes with a bass knob and a clipping indicator. For power inputs it will accept dual 0 awg for power
and dual 0 awg for ground.
Key Features
1 ohm stable
Variable low pass filter
Variable subsonic filter
Variable bass boost
Wired remote control
Dual 0 awg power and ground inputs (both must be used)
We recommend for installation
1 upgraded battery under the hood
3 extra 800ci battery in the rear
Minimum of two 0 awg ran from the front battery to the rear batterys
Both 0 awg power and ground inputson amp must have 0 awg ran to them for a total of 4 runs into the amp
2 upgraded aftermarket alternators
Dash mounted voltage meter
Features | Voltage | 7.5kw | |
Output Power (RMS) | 4 ohm | 14.4V | 2,000W x 1 |
2 ohm | 4,400W x 1 | ||
1 ohm | 7,500W x 1 | ||
1 ohm | 16V | 8,600W x 1 | |
1 ohm | 18V | 9,200W x 1 | |
Input Sensitivity | 6V~0.2V | ||
Low Pass Filter | Switchable | ||
( @ 24 dB Slope) | Variable | Hz | 35~250 |
Subsonic Filter | Switchable | ||
( @ 24dB slope ) | Variable | Hz | 10~50 |
Bass Boost | Variable | dB | 0-9dB |
Frequency Response | Hz | 15-270 | |
Signal to Noise Ratio | dB | 100 | |
Damping factor | 150< | ||
Efficiency @ 4ohm | % | Over 90% | |
THD @ 4ohms | Less than 0.1% | ||
Fuse Rating | 750 Amps | ||
Linked Fuse Rating | 1500 Amps | ||
Indicator | Power | Yes | |
Protection | Yes | ||
Clip | No | ||
Speaker & Power terminal | Mold Type | Yes | |
Power | Gauge | 0Ga x 2 | |
Heatsink Length | inch/mm | 32.28"/820mm |
Read more