DC Audio 9.0k - 9,000w Monoblock Amplifier

The 9.0kw competition series amplifier is a 9,000 watt mono block. It is capable of running up to 18 volts
for up to 11,000 watts. It is a linkable amp and designed to run at 1 ohm per amp or 2 ohms when strapped.
It comes with a bass knob and a clipping indicator. For power inputs it will accept triple 0 awg for power and triple 0 awg for ground.

 

Key Features
1 ohm stable
Variable low pass filter
Variable subsonic filter
Variable bass boost
Wired remote control
Triple 0 awg power and ground inputs

We recommend for installation
1 upgraded battery under the hood
3 extra 800ci battery in the rear
Minimum of two 0 awg ran from the front battery to the rear batterys
All 0 awg power and ground inputson amp must have 0 awg ran to them for a total of 6 runs into the amp
2 upgraded aftermarket alternators
Dash mounted voltage meter

	Features	Voltage	9.0kw
Output Power (RMS)	4 ohm	14.4V	2,400W x 1
2 ohm	4,800W x 1
1 ohm	9,000W x 1
1 ohm	16V	9,800W x 1
1 ohm	18V	11,000W x 1
Input Sensitivity			6V~0.2V
Low Pass Filter	Switchable
( @ 24 dB Slope)	Variable	Hz	35~250
Subsonic Filter	Switchable
( @ 24dB slope )	Variable	Hz	10~50
Bass Boost	Variable	dB	0-9dB
Frequency Response		Hz	15-270
Signal to Noise Ratio		dB	100
Damping factor			150<
Efficiency @ 4ohm		%	Over 90%
THD @ 4ohms			Less than 0.1%
Fuse Rating			900 Amps
Linked Fuse Rating			1800 Amps
Indicator	Power		Yes
Protection		Yes
Clip		No
Speaker & Power terminal	Mold Type		Yes
Power	Gauge	0Ga x 3
Heatsink Length	inch/mm		34.65"/880mm

Read more

9,000w Monoblock Amplifier9,000w Monoblock Amplifier